Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
246
Figure 185: Installing a Power Supply
NOTE
If power supplies are not installed in both power supply bays, be sure to install a cover over the
unoccupied bay. Unoccupied bays must always be covered to maintain proper system ventilation and EMI
levels.
4 Connect the AC power cord to the input connector on the power supply and rotate the wire clip into
place over the power cord connector.
5 Connect the other end of the power cord to an AC power outlet.
WARNING!
Always be sure that the source outlet is properly grounded before plugging the AC power cord into the
AC power supply.
To install a second power supply, repeat steps 1 through 5.
SH_202
To Next Page
Loading...
