Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
260
3 From the back of the equipment rack, slide the switch into place over the mounting brackets (see
Figure 202). Make sure the brackets slide between the support pegs on both sides of the switch.
Figure 202: Sliding the Switch onto the Rear Mounting Brackets
4 Push the switch forward as far as it will go, until the bracket support pegs are against the T of the
mounting bracket (Figure 203).
Securely tighten the rack mounting screws.
Figure 203: Fastening the Rear Mounting Brackets
SH_126
SH_128
To Next Page
Loading...
