Installing an EPS-160 External Power Module (with EPS-T)
Summit Family Switches Hardware Installation Guide
305
Figure 246: Redundant Power Connections
3 Connect an appropriate AC power cord to the AC connector on each unit.
NOTE
An AC power cord is not provided with the EPS-160 unit. For information about selecting a power cord,
see “Power Cord Requirements for AC-Powered Switches and AC Power Supplies” on page 500.
The Power LED on the front of the EPS-160 should light solid green to indicate that it is ready.
S450_008
To AC
Slot for plug
Redundant
power cable
Keyed end of
redundant power cable
To Next Page
Loading...
