Installing an EPS-C2 Chassis
Summit Family Switches Hardware Installation Guide
325
After the EPS-C2 has been installed in a rack, do the following to install a 750 W AC power supply in
an EPS-C2 chassis:
1 If necessary, grasp the two tabs on either side of the slot cover and pull gently to remove it from the
front of the EPS-C2 chassis (Figure 267).
Figure 267: Removing a Blank Panel from the EPS-C2 Chassis
2 Verify that the power supply is right side up (there is a sticker labeled “This Side Up”).
3 Carefully slide the power supply all the way into the slot in the EPS-C2 chassis (see Figure 268).
Push the power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
Figure 268: Installing a 750 W AC Power Supply in an EPS-C2 Chassis
ESP-C2_07a
ESP-C2_04
To Next Page
Loading...
