Extreme Networks Summit X150 Series - Page 329

Installing an EPS-C2 Chassis
Summit Family Switches Hardware Installation Guide
329
1 If necessary, slide the plastic cord retainer farther away from the back of the power supply
(Figure 273).
Figure 273: Moving the Power Cord Retainer on the 750 W AC Power Supply
2 Connect the AC power cord to the input connector (Figure 274).
Figure 274: Connecting the Power Cord on the 750 W AC Power Supply
3 Open the clip and slip it over the barrel of the connector (Figure 275).
ESP-C2_05
ESP-C2_06