Extron electronics NBP 100 - Installation Step 2: Prepare the Installation Site; Accessibility and Americans with Disabilities Act (ADA) Compliance

Network Button Panels • Hardware Features and Installation 9
Installation Step 2: Prepare the Installation Site
Steps and hardware required depend on the model being installed (see Site Preparation
on page10 for details).
ATTENTION:
• Installation and service must be performed by authorized personnel only.
• L’installation et l’entretien doivent être effectués uniquement par un technicien
qualifié.
• Extron recommends installing the NBP into a grounded, UL Listed electrical junction box.
• Extron recommande d’installer le NBP dans un boîtier d’encastrement électrique mis
à la terre, certifié UL.
• If the NBP will be installed into fine furniture, it is best to hire a licenced, bonded
craftsperson to cut the access hole and perform the physical installation so the
surface will not be damaged.
• S’il est prévu d’installer le NBP dans du beau mobilier, il est préférable de faire appel
à un artisan autorisé et qualifié pour couper le trou d’accès et réaliser l’installation de
telle façon que la surface ne soit pas endommagée.
• Follow all national and local building and electrical codes that apply to the installation site.
• Respectez tous les codes électriques et du bâtiment, nationaux et locaux, qui
s’appliquent au site de l’installation.
NOTES:
• For the installation to meet UL requirements and to comply with National Electrical
Code (NEC), the NBP must be installed in a UL Listed junction box. The end user or
installer must furnish the junction box. It is not included with the NBP.
• Read any installation instructions and regulatory guidelines that come with the
mounting devices (raceway, junction box, surface mounting box, mud ring) before
installing the mounting device.
• If the NBP is not mounted to a grounded metal junction box or a grounded metal
equipment rack, Extron recommends connecting the unit to an earth ground
to protect the unit from electrostatic discharge. For details, see the grounding
instructions on page14.
Select and prepare the site before cabling the controller. This may include cutting a hole
in the installation surface or installing a cabling raceway, running the cables to that site,
installing the wall box, and pulling cables through it.
Accessibility and Americans with Disabilities Act (ADA) Compliance
When planning where to install the NBP, consider factors affecting accessibility of the
controller such as height from the floor, distance from obstructions, and how far a user
must reach to press the buttons. For guidelines, see sections 307(“Protruding Objects”)
and 308(“ReachRanges”) of the 2010 ADA Standards for Accessible Design available at
http://www.ada.gov/regs2010/2010ADAStandards/2010ADAStandards.pdf.
• Installation and service must be performed by authorized personnel only.
• L’installation et l’entretien doivent être effectués uniquement par un technicien qualifié.