Network Button Panels • Firmware Updates 37
Updating the Firmware
Firmware upgrade tools require the PC and the NBP to both be connected to an Ethernet
network. The instructions for updating the firmware assume you have installed the
appropriate software on your PC first.
NOTES:
• You should save the existing configuration to a file (see the Global Configurator
Help File for instructions) before replacing the firmware. If the file is saved, the
configuration can be restored to the control processor or collaboration system
receiver later using GC.
• Check the Extron website for firmware-related documents, instructions, patch files,
and new firmware files before loading new firmware. We recommend that you read
the firmware release notes (available from www.extron.com) before beginning the
firmware update.
Locating and Downloading the Firmware
1. Visit the Extron website to find the latest firmware file for the NBP button panel. The
easiest way to locate files is through the Downloads tab on the web page for the
specific model.
2. Download the executable installer file (*.exe) from the website and run the installer
program. The program automatically stores the firmware file on the PC in C:\Program
Files\Extron\Firmware within a folder specific to that version.
3. Write down the firmware filename and location for later use. The filename ends in .eff
such as 49-476-50-x.xx.xxxx-yyyy.eff where x.xx.xxxx is the version
number.
NOTE: The firmware update file must have a filename extension of .eff. If the file
does not have that extension, it does not work properly.
Installing firmware
Firmware can be replaced by using one of the following:
• Global Configurator (using the Update Firmware link to Toolbelt)
• Toolbelt (the stand-alone program)
• The firmware uploader feature in the default embedded web page
These methods allow you to browse to find and select the appropriate .eff file on your PC
and then click an Upload button to initiate the firmware upload to the unit.
NOTE: Toolbelt allows you to update multiple devices with the same firmware version
simultaneously.
Allow at least a couple minutes for the firmware to finish uploading. At the end of the upload
process, the unit partially reboots and loses its connection to the PC. Therefore, to continue
using the web page or Toolbelt you need to refresh the web page or reconnect via Toolbelt
after the firmware update.
NBP: 49-476-50
IPCP/IPL Pro:
49-247-50-0.00.0074-full.eff
To Next Page
Loading...