Fabdec DARI-KOOL GALA-KOOL Pro - Page 43

Page 43
8. Setting of parameters
Display parameter value
Use the arrow keys to select the desired parameter.
Press the "SET" button: The parameter value is displayed
Change parameter value
Use the arrow keys to select the desired parameter.
Hold down the "SET" button and use the arrow buttons to set the desired
value. (If the arrow buttons are held, the value starts to run)
Note:
first release the arrow button In order to store the value in the memory,
and then the "SET" button.
Return to working level:
(possible from any parameter)
Standard saving the values:with
Press both arrow buttons simultaneously The display shows "STOR" for a short .
time - changes are accepted. The control switches to the OFF mode - the display
shows the current time.
Return saving the values:without
Press the OFF button - or
If no button is pressed for 60 seconds:
The controller automatically returns to the OFF mode.
All changes are lost.
OFF
SET
OFF