6.2 Cleaning programme diagram
Only available when activated in parameters
Switch-on delay for heater
Post-heating temperature during main circulation
Cleaning pump venting (if set in parameter [r80])
and 6.1.4Only required in case of cleaning method ‚green' (see section 6.1.3 ).
n
n11
D
H
Cleaning cycles, cleaning stages
and programme steps:
A cleaning cycle consists of different
" ".cleaning stages
Each cleaning stage consists of sev-
eral 'programme steps'.
programme step
Designation of the , with which the corresponding times are setn-parameters
For the first parameter of each cleaning stage the following can be parameterised: Water intake by level
Adjustment of dosing times for detergents
Heat-up time (variable - until the set temperature is reached)
During the cleaning process the current
programme step is displayed.
The flashing point indicates activity.
6. Cleaning
Level 1
Level 2
Level 1
Level 2
Level 1
Level 2
Level 1
Level 2
Cleaning cycle
Clean. stg 0
Cleaning stage 1 Cleaning stage 2 Cleaning stage 3 Cleaning stage 4
Rinse out Pre-rinse 1 Pre-rinse 2 Main rinse 1 Intermediate rinse 1
agitator
compressor
cold water valve
warm water valve
alk. detergent
acid detergent
drain valve
cleaning pump
heater
cleaning active
disinfection
T1
T2
°C
Page 20
To Next Page
Loading...