8. Setting of parameters
Runtime abort for all cleaning stages
n100 Drain time after cleaning has been aborted 0 .. 999 sec. 90
Dosing time settings
n101 Dosing time alkaline detergent 0 .. 999 sec. 100
n102 Dosing time acid detergent 0 .. 999 sec. 100
n103 Dosing time disinfection (hidden if r47 = 0) 0 .. 999 sec. 60
Temperature settings (see also section .1 )9 1
n106 Pre-heat. temp. main cleaning stage 1 (alkal./acid) 0 .. 99,9 °C 4 ,08
(hidden if r35 = 0)
n107 Pre-heat. temp. main cleaning stage 2 (acid) 0 .. 99,9 °C 4 ,08
(hidden if r35 = 0 or 1)
n108 Pre-heat. temp. main cleaning stage disinfection 0 .. 99,9 °C ,030
(hidden if r35 = 1 or 2)
n109 Post-heating temp. during circulation 0 .. 99,9 °C 40,0
in main cleaning stage 1 [n34] (hidden if r35 = 0)
n110 Post-heating temp. during circulation 0 .. 99,9 °C 40,0
in main cleaning stage 2 [n54] (hidden if r35 = 0 / 1)
n111 Post-heating temp. during circulation 0 .. 99,9 °C ,025
in cleaning stage disinfection [n74] (hidden if r35 = 0 / 1 / 2)
Page 53
To Next Page
Loading...