Setting Default
Fault configuration...
F1 ... high milk temperature (level 1) 12 .. 13 13
F2 ... high milk temperature (level 2) 12 .. 13 13
F3 ... high milk temperature (level 3) 12 .. 13 13
F6 ... power failure alarm 12 .. 13 13
F11 ... minimum cleaning temperature not reached 7 .. 13 11
F12 ... min. wash temp. not maintained long enough 7 .. 13 11
F15 ... agitator fault in cooling mode 7 .. 13 11
F16 ... timeout "No agitator action" 7 .. 13 11
F20 ... cooling time exceeded for first milking 7 .. 13 11
F22 ... Cooling mode switched off 7 .. 13 11
F23 ... milk temperature high over period of time 7 .. 13 11
F25 ... max. milk temperature exceeded 7 .. 13 11
F27 ... milk temperature too low over period of time 7 .. 13 11
F29 ... min. milk temperature exceeded 7 .. 13 11
F30 ... power failure (direct) 7 .. 13 11
F31 ... max. time without cleaning ) (after end cool. mode 7 .. 13 11
F32 ... max. time without cooling (after cleaning mode) 7 .. 13 11
F33 in. cleaning interval ... m 7 .. 13 11
F34 ... time / date not set 7 .. 13 11
F35 ... alkaline drum empty 7 .. 13 11
F36 ... acid drum empty 7 .. 13 11
F38 ... temperature difference exceeded 7 .. 13 11
monitoring sensor
F39 ... battery voltage too low 7 .. 13 11
F40 ... safety switch butterfly valve 1 .. 13 6
F41 ... pressure switch cleaning pipe 1 .. 13 6
F42 ... thermo cleaning pump-protection 1 .. 13 6
F43 ... manual interruption of cleaning 1 .. 13 6
F44 ... timeout water intake by level 1 .. 13 6
F45 ... water in the tank after draining 1 .. 13 6
F46 ... w ater inlet time monitoring 1 .. 13 6
F48 ... timeout heating time cleaning 1 .. 13 6
F49 ... over-temperature heater 1 .. 13 6
F51 ... ank overflow protection t 1 .. 13 6
F52 ... water in tank cooling mode 1 .. 13 6
F53 ... thermal protection compressor 1 .. 13 6
F54 ... agitator-condition monitoring direct 1 .. 13 6
F55 ... Timeout dependent cooling start‘volume ’ 1 .. 13 6
F56 ... sensortemperature fault 1 .. 13 6
F57 ... sensor short circuit temperature 1 .. 13 6
F58 ... sensor rangetemperature out of 1 .. 13 6
F60 ... agitator monitoring fault 1 .. 13 6
F61 ... sms module fault 1 .. 13 4
F62 ... IO-Module fault 1 .. 13 6
F80 ... Fault configuration Low pressure message 1 .. 13 6
F81 ... Fault configuration High pressure message 1 .. 13 6
F85 ... Fault configuration phase error 1 .. 13 6
F99 ... Test alarms 1 .. 13 11 (see section 9.18)
Critical
tank monitor alarm
(always red LED)
Depending on the setting,
it is an informative or a
critical tank monitor alarm
(green or red LED)
Depending on the setting
it is an informative or a
critical tank monitor alarm
or a system alarm
(Green or red LED
or display only)
Page 65
8. Setting of parameters
To Next Page
Loading...