16 < < < <
3) Remove the glass by removing the glass clamps C (see fig. 10) for
instance with a screwdriver. Careful when removing the glass! Wear
gloves! Before placing the glass back, be sure that there are no
fingerprints on the glass. hey will be burnt in.
4.3 Fitting the firebox
1) Seal off the firebox with a glass fibre seal, when using a debris
catcher;
2) Put the firebox in the fireplace opening;
3) If the appliance is placed on a combustible floor then a fibrelux or
similar heatproof board of 12 mm thickness should be placed under
To Next Page
Loading...
