> > > > 29
• Do not use the fire with broken or missing logs.
8.1.1 Cleaning the glass
Depending on the intensity of use, you can get a deposit on the glass. This
can be removed with a special non abrasive ceramic glass cleaner
(ceramic cook-top cleaner) as follows:
1) Remove the glass frame as described at 4.2.
2) Clean the glass. Handle the glass with clean hands or wear gloves.
3) To fit the glass, proceed in reverse order. Make sure that the log set
has been installed correctly before fixing the glass.
Attention:
Before placing the glass, check if the glass sealing rope is in good
condition. Be sure that there are no fingerprints on the glass. Once they
are burned in it is not possible to remove them.
8.1.2 Cleaning the combustion chamber and burner
You can clean the combustion chamber with a vacuum cleaner excluding
the burner surface.
If the burner is visibly damaged, this can affect the distribution of the
flame. If so, replace the burner.
8.1.3 Burner tray assembly
1) Remove the front, glass, trim, log set, grid and burner tray cover.
2) Break the gas supply at the control valve.
3) Unscrew the burner and take it out of the combustion chamber.
To Next Page
Loading...
Need help?
General
