> > > > 41
2) To enable knob B turn knob A to the position;
3) To extinguish the pilot turn control knob A to position z, although it
is in order to leave the pilot permanently lit.
10.3.1 When the pilot extinguishes
Warning! When the pilot extinguishes, for whatever reason, you should
wait at least 5 minutes before trying to turn it on again.
Possible causes of pilot extinguish are:
• Operating error;
• Interference of the safety device;
• Failure in the pilot flame system.
Contact a qualified installer when the appliance goes off regularly.
10.4 Remote control version
There are two types of remote controls. All models, except the Serene,
are equipped with a remote control which uses radio requency for the
transmission of signals. This remote control is intended for fireplaces
installed in a domestic setting in all EU countries, except Austria,
Denmark, Finland and Greece.
The Serene is fitted with an other kind of remote control which uses Utra
Sound and works on batteries. Depending on the frequency of use, the
batteries have to be replaced every year.
Both remote controls are only meant to regulate the flames from off till
max.. They only functions when the pilot burner is ignited and knob A in
(big flame) position. It is therefore not possible to ignite or extinguish
the pilot flame with the remote control.
To Next Page
Loading...
Need help?
General
