42 < < < <
Features:
• Manual control will always remain possible.
• Both remote controls are internationally
approved.
• The remote control which uses radio frequency
generates a unique safety code every time you
activate the transmitter, it's similar to those
used in a car.
• Both remote controls are easy to install
retrospectively.
10.4.1 To light
1) Push in and turn the control knob (A) from z
anticlockwise to the setting
(small flame). You
will hear an ignition click. Check that the pilot is
lit (if not repeat).
2) Continue to hold in the control knob for a further
ten seconds to ensure that the pilot flame is
stable.
3) Release the knob. The pilot should remain alight.
4) Turn the control knob A to the
position.
5) Set the on/off switch on the receiver to "on”.
or d low flame
or c high flame
6) Use
or d (high) and or c (low) to achieve
the desired heating and flame effect.
Fig. 29: Radio
Frequency RC
Fig. 30: Ultra
Sound RC
To Next Page
Loading...
