> > > > 43
7) You will hear a beep every time the receiver recognises a good
signal. (If not, see paragraph 10.4.3).
8) When the fire is not used for a prolonged period, turn off the pilot.
10.4.2 To extinguish
1) Push (low) till the burner goes out and a clicking noise can be heard;
2) To enable the remote control turn knob A to the
position.
3) To extinguish the pilot turn control knob A to position z although it
is in order to leave the pilot permanently lit.
10.4.3 Setting the right transmission code
The transmission code has been set in the factory. However the code can
disappear if the receiver is disconnected for a longer period.
1) Push the "mod" button on the receiver and hold it for 3 seconds;
2) The green control lamp will light up and stay on. Repeat if not;
3) Push a button on the remote control. The control lamp on the
receiver should go out;
4) Again push a button on the remote control. The lamp starts flashing
and will switch off eventually;
5) The receiver now recognizes the remote control. The remote control
now functions;
6) Check if you can hear a sound and the motor runs, when you push a
button on the remote control. (If not so please check the batteries).
10.4.4 Changing the batteries
There is no risk of electric shock as the low voltage supply is similar to
that used in torches. Always turn off the appliance before changing
batteries.
To Next Page
Loading...
Need help?
General
