6 < < < <
2. SAFETY AND GENERAL INFORMATION
Before installation, ensure that the local distribution conditions
(Identification of the type gas and pressure) and the adjustment of the
appliance is compatible.
This gas appliance is factory set and shall not be adjusted by the
installer.
The spillage monitoring system must not be put out of operation.
This appliance does not contain any component manufactured from
asbestos or any asbestos related products.
2.1 General safety
It is the law in the UK that all gas appliances, are installed by a
competent person in accordance with the Gas Safety (Installation and
Use) Regulations (As amended), the relevant British Standards for
Installation work, Building Regulations, Codes of Practice and the
manufacturer’s instructions.
The installation should also be carried out in accordance with the
following where relevant:
• BS8303 BS5871 Part1
• BS5440 Parts 1&2 BS715
• BS6891 BS1251
• Building Regulations Document J (as applicable).
• Building Regulations and Standards issued as relevant by the
Department of the Environment or the Scottish Development
Department.
In the Republic of Ireland installation should be carried out in accordance
with IS813, ICP3, IS327, Building Regulations, Codes of Practice, the
manufacturer’s instructions and any other rules in force.
To Next Page
Loading...
Need help?
General
