Page 2/3 Safety Instructions
2 Safety Instructions
The measurement evaluation unit UM-X is a stand-alone filling level display for continuous
level sensors. Use the system exclusively for this purpose. The manufacturer accepts no liability
for any form of damage resulting from improper use.
The measurement evaluation unit UM-X has been developed, manufactured and tested in ac-
cordance with the state-of-the art technology and the generally accepted safety standards.
Nevertheless, hazards may still arise. For this reason, the following safety instructions must be
observed:
• Do not change or modify the system or add any equipment without the prior con-
sent of the manufacturer.
• All installation and maintenance work, with the exception of functional testing,
must be carried out with the power disconnected.
• The measurement evaluation unit UM-X must be installed outside the potentially
explosive area.
• The installation, operation and maintenance of the measurement evaluation unit
UM-X must be carried out only by expert personnel. Specialised knowledge must
be acquired by regular training.
• Operators, installers and service technicians must comply with all applicable safety
regulations. This also applies to any local safety and accident prevention regula-
tions which are not stated in this guide.
The safety instructions in this user guide are marked as follows:
If these safety instructions are not observed, it may result in the risk of accident or
damages to the system.
Useful information which ensures continued and correct operation of equip-
ment and makes your work easier.
2.1 Password
You will need a password for certain menu options in order to be able to ac-
cess or amend the points in question.
The password will be advised on an attached sheet and may only be used by
trained personnel!
To Next Page
Loading...
Need help?
General