Fagor EVOconcept CCO-120DCW - Page 81

81
7 FAULTS AND BREAKDOWNS
A list of possible causes and solutions in the event of anomalies or operating errors is given below. In the
event of doubt, or if you are unable to resolve the problem, please contact the technical service.
PRECAUCIÓN
PRÉCAUTION
WARNING
VORSICHT
PRECAUZIONE
DİKKAT
TENSIÓN PELIGROSA
TENSION DANGEREUSE
HAZARDOUS VOLTAGE
GEFÄHRLICHE SPANNUNG
TENSIONE PERICOLOSA
TEHLİKELİ VOLTAJ
THIS APPLIANCE MAY ONLY BE REPAIRED BY AN AUTHORISED AND QUALIFIED
TECHNICAL SUPPORT SERVICE USING PARTS SUPPLIED BY THE MANUFACTURER.
THE MANUFACTURER MAY NOT BE HELD LIABLE FOR ANY PROPERTY DAMAGE OR
PERSONAL INJURY RESULTING FROM THE INCORRECT INSTALLATION, USE,
MAINTENANCE OR REPAIR, OR CAUSED BY FAILURE TO COMPLY WITH THE
STANDARDS AND INSTRUCTIONS PROVIDED.
FAULT
POSSIBLE CAUSE
ACTION
The machine
does not come
on.
The appliance does not receive mains
power.
Check whether the magneto-thermal circuit breaker
or the differential switch has tripped.
Emergency button activated.
Check whether the emergency button is activated.
Blown fuses.
Call the technical service to have it replaced and the
cause analysed.
Water does not
enter the
machine.
Interruption to the supply of water or the
intake water valve is closed.
Check whether there is water in the main system and
open the shut-off valve.
Rinse nozzles blocked.
Clean the nozzles. If there is a build-up of lime on the
arm, contact the technical service to have the
appliance cleaned.
Solenoid valve filter blocked.
Call the technical service to have it cleaned.
Faulty solenoid valve.
Call the technical service to replace it.
Pressostat is broken.
Call the technical service to replace it.
Incorrect wash.
There is no detergent.
Refill the detergent.
Insufficient detergent.
Call the technical service to reset the dispenser.
Wash distributors obstructed.
Clean distributors thoroughly.
Dirty filters.
Clean the filters thoroughly.
Presence of foam.
Inadequate detergent. Change detergent.
Too much rinse aid. Call the technical service to reset
the dispenser.
Temperature in tank less than 50 ºC /
122 ºF.
Faulty thermostat or incorrect setting. Contact the
technical service.
Dirt on the dishes.
Select a lower wash speed according to the dirt on
the dishes.
Water too dirty.
Drain the wash tub and fill with clean water.
Dishes and
kitchenware are
not dry.
There is no rinse aid
Fill the rinse aid container.
Insufficient rinse aid.
Call the technical service to reset the dispenser.
Dishes left inside dishwasher for too
long.
Remove the dishes at the end of the wash cycle and
leave to dry by evaporation for a minute.
Rinse temperature lower than 80 ºC /
176 ⁰F.
Allow the boiler to reach the rinse temperature before
starting the cycle. If the problem persists, call the
technical service.
Dryer module does not operate
correctly.
Contact your Technical Assistance Service.
Too much rinse aid.
Call the technical service to reset the dispenser.