ATTENTION
THE ELECTRICAL SYSTEM OF THE MACHINE IS NOT IN ANTI-EXPLOSIVE
EXECUTION (NO ATEX): THEREFORE YOU SHOULD CAREFULLY AVOID ITS
USE IN AREAS SUBJECT TO ATEX RISK.
When travelling on the ground:
✓ Cautiously move the machine avoiding sudden manoeuvres;
✓ DO NOT CARRY PERSONS on the base frame of the machine and
in any other position except in the work station inside the platform;
✓ Check the structural condition and cleanliness of the surfaces on which
the machine is used (make sure the surface is suitable for the weight of
the machine in work conditions).
During ascent and descent:
✓ Comply with the maximum admissible loads for the work platform;
✓ Make sure there are no overhead upright obstacles along the trajectory;
✓ Do not cause dangerous vibrations and/or oscillations that would result
in loss of machine stability and possible tipping over.
ATTENTION
BEFORE STARTING THE MACHINE, INSERT THE STABILISERS IN THE
APPROPRIATE SEATS (UNTIL THEY STOP) AND LEVEL THE BASE BY
ADJUSTING THE STABILISER'S FEET. PAY CAREFUL ATTENTION WHEN
SLIGHTLY LIFTING THE MACHINE'S WHEELS SO THAT THEY REST ONLY ON
THE STABILISER'S FEET.
To Next Page
Loading...