ATTENTION
ON THE LOWER PART OF THE BASE THERE IS A SAFETY WHEEL THAT
PREVENTS THE TELESCOPIC STRUCTURE FROM LIFTING, UNLESS THE
STABILISERS ARE INSERTED AND THE PLATES ARE ENGAGED. WHEN
LIFTING THE MACHINE ON THE PLATES TO STABILISE AND LEVEL IT, THE
SAFETY WHEEL LIFTS FROM THE GROUND ENABLING THE TELESCOPIC
STRUCTURE TO LIFT.
NOTE: If the machine base is not raised enough during the initial
stabilisation phase (and the wheel for checking that the base is lifted
is still on the ground), when trying to lift the cage, the machine will
not lift.
Restore machine operation as follows:
1) Make sure the stabilisers are properly and fully engaged;
2) Raise the stabilisers until the wheel for checking that the base is
lifted comes off the ground;
3) Use a spirit level to ensure the base is properly levelled;
4) Lift the cage.
To Next Page
Loading...