Fargo DTC1000 User Manual

© 2010 HID Global Corporation All rights reserved
DTC1000/DTC4000 Card Printer/Encoder User Guide (L001398, Revision 1.2)
104
Section 8: Cleaning
The Card Printer is built to require a minimum amount of maintenance. Nevertheless, there are a few
procedures you can perform on a regular basis or as needed to ensure the best possible performance
Safety Messages (review carefully)
Symbol
Critical Instructions for Safety purposes
Danger:
Failure to follow these installation guidelines can result in
death or serious injury.
Information that raises potential safety issues is indicated by a
warning symbol (as shown to the left).
• To prevent personal injury, refer to the following safety
messages before performing an operation preceded by this
symbol.
• To prevent personal injury, always remove the power
cord prior to performing repair procedures, unless otherwise
specified.
• To prevent personal injury, make sure only qualified
personnel perform these procedures.
Caution:
This device is electrostatically sensitive. It may be
damaged if exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).
• To prevent equipment or media damage, refer to the
following safety messages before performing an operation
preceded by this symbol.
• To prevent equipment or media damage, observe all
established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.
• To prevent equipment or media damage, always wear an
appropriate personal grounding device (e.g., a high quality
wrist strap grounded to avoid potential damage).
• To prevent equipment or media damage, always remove
the Ribbon and Cards from the Printer before making any
repairs, unless otherwise specified.
• To prevent equipment or media damage, take jewelry off
of fingers and hands, as well as thoroughly clean hands to
remove oil and debris before working on the Printer.

Fargo DTC1000 Specifications

General

Product color	Black, Silver
Internal memory	32 MB
Built-in barcodes	-
Total input capacity	100 sheets
Maximum resolution	300 x 300 DPI
Print speed (color)	120 card/h
Print speed (monochrome)	515 card/h
Compatible operating systems	- Windows XP / Vista (32 bit & 64 bit) / Server 2003 & 2008 / Windows 7 / - Linux
Bundled software	Swift D Embedded Badging Application, ARGO Workbench Diagnosis Utility
Interface	USB
Optional connectivity	Ethernet

Weight and Dimensions

Weight	3400 g
Dimensions (WxDxH)	475 x 234 x 249 mm