© 2010 HID Global Corporation All rights reserved
DTC1000/DTC4000 Card Printer/Encoder User Guide (L001398, Revision 1.2)
33
Swift ID Installation Instructions
Here are the related definitions for the Swift ID installation instructions.
• Swift ID: This is a ‘built-in badging’ application which enables Users to create simple ID badges
without having to install any additional software. (Note: This application is only intended for use
between one Printer and one PC. The application cannot select between Printers; also, only one
Printer on a PC can access Swift ID.)
• HID EEM Driver: This Driver is used by Swift ID to communicate with the PC when connected via a
USB cable. (Note: It is also known as an ‘ETHERNET Emulation Module’.)
• EEM Device Flag (i.e., Enable Swift ID over a USB connection): Check this item to utilize Swift ID
via a USB connection. (Note: When this box is checked, the Ethernet connection (if applicable) on
the Printer will not be operational.)
o If this flag or selection is not accessible, it means the HID EEM Driver (that Swift ID uses to
connect via a USB connection) has not been installed. (Note: This Driver can be found on
the installation CD or it can be downloaded from the HID Global support page.)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
