Fargo DTC4250e - Page 59

DTC1000Me-1250e-4250e-4500e Card Printer Service Manual PLT-01543 rev 1.0
November 2013 59
.
Step
Procedure
3
Slide the Supply Spindle DOWN To release. Slide the Motor UP to install.
NOTE: You do not need to remove the gears or the Stepper Motor for this procedure.
NOTE: If ribbon wrinkle occurs after replacing the motor, move the motor assembly DOWN slightly in
the frame. Loosen the 2- F000178 screws from the supply spindle, move down 1/16
th
inch then
tighten the F000178 screws.
4
Remove the RFID cable (D930603) from the Supply Spindle.
Remove the Encoder Sensor cable harness (D930600) from the encoder sensor.
NOTE: The routing of these wires under the clip.
5
Replace the complete assembly Motor.
Reconnect wires.
6
Procedure is complete.