Chapter 2. Printer Operation
2.1. Introduction
This chapter provides the procedures to do the following tasks:
●
Installation method used for the first time
●
Start print
●
Tu r n of f t h e p r in t e r
●
Manage message
●
Manage user field
●
Print configuration
2.2. Installation method used for the first time
2.2.1 Manually Ink Injection
Inject ink into pipe system in order to exhausting the air. Because the pipe
system is full of air, when the printer is first install.
The procedures are as follow:
1. Tu r n on t h e pri n t e r. O pe n t h e d oo r o f ink C o m p a r tm e n t . P u ll t h e p i pe
system out.
2. Inject ink into the mixer tank according to the following figure(Figure
2-1).
To Next Page
Loading...