Fastjet A400 Series - Nozzle Cleaning

3.4 Nozzle Cleaning
1. In the “System” menu select the “Nozzle Flush”.
Figure 3-2. Nozzle Flush screen
2. When the “F1” function on the main screen showed “Stop Flus”, use
cleaner wash the position of print header shown in flowing picture until the
“F1” function show “Start Printing” again.
Figure3-3. Nozzle Flush
Note
“Nozzle Flush” function can be used in starting print, printing state and
in the process of stopping. According to the actual state to increase the
time of nozzle cleaning.
 41