2.8.4 Reverse Mode
This mode widely used to in electronic, label printing, egg and other
industries. It provides the effective production for the array printing.
To u s e Re ver s e M o d e n e e d t o s e t :
1. User the arrow keys to open Print menu.
2. If you want to use meter mode to print . You should set Print
Enable, Continuous Print, Photocell Level, Photocell Signal
Block and Reverse Print Config menus.
a. Print Enable menu.
Figure2-28. Print Control menu
●
Select Print Enable option.
●
Set the Shaft Encode to Measure option.
●
If pec2 is connected, select Reset or Close.
●
Do not need to set.
●
Do not need to set.
b. Continuous Print menu.
To Next Page
Loading...