3.2 Overview of Operation Modes
FRENIC-Lift features the following three operation modes:
Running mode: This mode allows you to enter run/stop commands in regular operation. You can also
monitor the running status in real time.
Programming mode: This mode allows you to set function code data and check a variety of information
relating to the inverter status and maintenance.
Alarm mode: If an alarm condition arises, the inverter automatically enters the Alarm mode. In this
mode, you can view the corresponding alarm code* and its related information on the
LED and LCD monitors.
Alarm code represents the type of alarms that have been triggered by the protection function. For details, refer to
the FRENIC-Lift Instruction Manual (INR-SI47-1038-E), Chapter 8, Section 8.5 "Protection Features."
Figure 3.1 shows the status transition of the inverter between these three operation modes.
Figure 3.1 Status Transition between Operation Modes
3-4
To Next Page
Loading...