Chapter 2 INSTALLATION AND INTERCONNECTION
2.1 Accessories and Parts Required for Interconnection
To install the multi-function keypad on the enclosure’s panel instead of the inverter, you need the following
accessories and parts:
Accessories/Parts Type or Specifications Remarks
Remote operation extension cable*
1
CB-5S, CB-3S, or CB-1S
You have a choice of three lengths: 5 m, 3
m, and 1 m.
Screws
(for mounting the multi-function keypad)
M3 x
*
2
Provide 2 screws (to be provided by the
customer) beforehand.
*1: Alternatively, you can use an off-the-shelf 10BASE-T/100BASE-TX LAN cable (straight type) that meets the
ANSI/TIA/EIA-568A Category 5 standard (maximum length: 20 m).
Recommended LAN cable:
Manufacturer: Sanwa Supply, Co. Ltd.
Model: KB-10T5-01K (for 1 m)
KB-STP-01K (for 1 m) (shielded cable, EMC-compliant)
*2: Use the screws of the length just right for the panel. (See Figure 2.7.)
2-1
To Next Page
Loading...