Feasa ICT Series

FEASA LED ANALYSER
ICT VERSION
AUTO CAPTUREPWM - Capture PWM LED Data...............................................................63
MANUAL CAPTURE - Capture PWM LED Data for a specific range..................................64
CAPTUREMULTI - Multiple Capture Command....................................................................65
Get Data Commands......................................................................................................................66
Under Range Condition.................................................................................................................66
Over Range Condition...................................................................................................................66
Incorrect Capture Mode.................................................................................................................66
getRGBI## - Get RGB and Intensity for a LED.......................................................................67
getHSI## - Get Hue, Saturation and Intensity..........................................................................68
getxy## - Return the xy Chromaticity values...........................................................................69
getxyi## - Return the xy Chromaticity & Relative Intensity values.........................................70
getXOFFSET## - Return the x Chromaticity offset.................................................................71
getYOFFSET## - Return the y Chromaticity offset.................................................................72
getUV## - Return the u'v' Chromaticity values........................................................................73
getWAVELENGTH## - Get the Dominant Wavelength...........................................................74
getWAVELENGTHOFFSET@@ - Get the Dominant Wavelength Offset..............................75
getWI## - Get the Dominant Wavelength & Intensity..............................................................76
getWSI## - Get the Dominant Wavelength, Saturation & Intensity.........................................77
getCCT## - Get the Correlated Colour Temperature................................................................78
getINTENSITY## - Get the Intensity.......................................................................................79
getINTGAIN## - Get the Intensity Gain Factor.......................................................................80
getFACTOR - Get the exposure Factor.....................................................................................81
get7SEG# - Get the value of a 7 Segment Display...................................................................82
getABSINT@@ - Get the Absolute Intensity Value of the Led under test...............................83
getAUTOPWM - Get which Auto Capture Mode is active C or CPWM.................................84
General Commands............................................................................................................................85
General Set Commands.................................................................................................................85
set/putFACTOR## - Set the Exposure Factor...........................................................................86
set/putLOG - Change the Intensity Response of the Analyser to Logarithmic mode...............87
set/putLIN - Change the Intensity response of the Analyser to Linear Mode...........................88
set/putINTGAIN - Set the Intensity GainFactor.......................................................................89
set/putXOFFSET##0.xxx - Set the x Chromaticity Offset.......................................................90
set/putYOFFSET##0.xxx - Set the x Chromaticity Offset.......................................................91
set/putWAVELENGTHOFFSET@@±## - Set the wavelength Offset....................................92
setBAUD - Change the baud rate..............................................................................................93
setAUTOPWM# - Change the Auto Capture mode to Auto PWM Mode................................94
setFREQUENCYxxx - Set the Frequency Output Mode of the Analyser................................95
General Get Commands.................................................................................................................96
getSERIAL Get the Serial Number of the Analyser.................................................................96
getVERSION - Get the Firmware Version................................................................................97
getBAUD - Get the Baud Rate..................................................................................................98
getHW - Get the Hardware Version..........................................................................................99
getSTATUS - Get a summary of the Led Analyser details......................................................100
getICTSTATUS - Get the Led Analyser ICT Mode details....................................................101
EOT - End of Transmission Character....................................................................................102
User Calibration Mode....................................................................................................................103
Introduction:............................................................................................................................103
4