Feasa ICT Series

FEASA LED ANALYSER
ICT VERSION
Get Data Mode
getFACTOR - Get the exposure Factor
Transmit Receive
getfactor xx
Where:
xx represents the exposure factor value. The default value is 01.
Description
This command is used to get the exposure factor value for all Fibers.
The default value set at the factory are 01. The values can be adjusted by the SetFactor
command.
Example:
The PC transmits getfactor to the LED Analyser to instruct it to send the stored exposure
factor for all Fibers. The default value is 01.
getfactor
01
Back to Index
81