FEC HFC3000 - Chapter 7 Troubleshooting; Abnormal State Display

Chapter 7 Troubleshooting
PAGE 7-2
7-1 Abnormal State Display
When an error occurs in the tool or the controller, the abnormal state No. is indicated in the WORK
part and the sub code is indicated in the COUNT/D-No. part of the indicator.
Abnormal State No.
PAR No. Indication
Abnormal Type
A.01
Torque Transducer Error
A.03
TOOL ID Error
A.04
System Memory Error
A.05
Servo Reply Error
A.06
Servo Type Error
A.08
Servo Amplifier Error
A.09
Setting Data Error
Sub code indication
Abnormal state signal indication