Chapter 8 Options
PAGE 8-3
Storing Data in the Memory Card
1. Insert the memory card in the memory card slot (CF CARD) in the state where the power of the
controller is OFF.
・ When the control power of the controller is turned ON with the memory
card installed in the slot, it takes more than the regular time for the
controller to become operable because a file storage folder is generated in
the memory card.
・Insert vertically the memory card slowly and with its top surface at the left
side. Although arrangements are made so that a card cannot be inserted in
the opposite orientation, a malfunction of the controller or the card may
occur if the card is pressed in forcibly.
・Be sure to set the memory card when the controller is not performing a
fastening operation.
2. Data storage is executed after the fastening operation is ended in the state where the memory
card is set.
・ Do not extract the card from the slot or turn OFF the control power of the
controller while storage into the memory card is in progress. Otherwise,
the stored data or the memory card may become damaged.
3. When data are being stored in the memory card, the CF ACCESS LED is lit up in green.
If storage in the memory card fails, the CF ACCESS LED lights up in red.
Flow of Data Storage
The fastening results and the fastening curves are stored in the memory card.
The fastening results are stored according to date in the TSV format and can be displayed in
Microsoft® Excel®.
In regard to the fastening curves, the torque vs. angle (180deg) curve of each axis is stored in the
“nracd” format, which is dedicated for use with the HFC3000 User Console.
The fastening curve displayed on the “Curve Monitor” of the HFC3000 User Console can be stored
in the TSV format.
Please refer to “Wave Monitor” of the <<HFC3000 User Console Instruction Manual>>
concerning the display of the curve.
CF ACCESS
Green: Data storage in progress.
Red: Data storage failed.
To Next Page
Loading...
