Chapter 9 External Interface
PAGE 9-3
② HFC3000 [HFC3000→PLC]OUT signal specification
The output signal fixed layout.
Outputs when N/R operation ends.
Outputs when fastening result OK.
Outputs when fastening result NG.
Turned on when reverse by manual operation.
Siganl is off in RESET,PROGRAM or next cycle starts
Output echo of fieldbus message bank input BIT.
Outputs when Job Cycle Accept
Fastening Result
Data Available
Ouput while fastening result data exist
Output when the remainder capacity of the CF card is 1%
or lower
Outputs echo of work select.
Outputs echo of work select.
Outputs echo of work select.
Parameter No.
Outputs when fastening result NG.
Outputs when fastening result OK.
Outputs when system abnormality occurs.
Outputs when system ready condition.
Outputs during fastening or reverse operation.
Outputs when program mode status.
To Next Page
Loading...
