Chapter 4 Installation
PAGE 4-11
BATCH OK RESET: BATCH COUNTER RESET SIGNAL PIN No.: TB3-5
When a change of WORK has been selected at the terminal block, the current cycle count value is
cleared by input of this reset signal.
When a change of WORK has been selected at the controller indicator panel, the current cycle count
value is cleared by input of this reset signal. Or, after performing fastening for the set number of
times, the cycle count value is cleared automatically at the start of the next fastening process.
BANK SELECT: OUTPUT SIGNAL BANK SELECT SIGNAL PIN No.: TB1-12
The contents of the eight output signals are changed by switching ON/OFF the BANK SELECT signal.
UNUSED PIN No.: TB3-6, 9, 10
These are unused.
To Next Page
Loading...
