Chapter 6 Description of Operations
PAGE 6-7
6-2-2 Indications in the RUN Mode
In the real time mode, [Mon.] is indicated on the WORK Indication Part.
The value in the COUNT/D-No. indication part is incremented or decremented with the [▲] or [▼]
switch to change the indicated content.
Also, the value in the COUNT/D-No. indication part can be skipped by 5 at a time by long-pressing the
[▲] or [▼] switch.
“WORK” “COUNT/D-NO” “DATA”
Torque Value Indication
Torque Voltage Value Indication
Maximum Torque Value Indication
Fieldbus
status monitor
Please refer to the “List of Contents Indicated in the Real Time Mode” regarding the respective data
contents indicated at the DATA indication part when “COUNT/D-No.” is changed.
・When the CAL switch or the RESET signal is input in the ”ON” state when any of
D-Nos. 3 ~ 7 is indicated, the torque will not be indicated at the upper stage of the
indicator (the check itself will be executed).
・When the CAL switch or the RESET signal is input in the ”ON” state in the real time
mode, “CAL” or “RES” will not be indicated in the D-No. indication part.
To Next Page
Loading...
