Need help?Do you have a question about the Feig Electronic TST WU and is the answer not in the manual?
General| Brand | Feig Electronic |
|---|---|
| Model | TST WU |
| Category | Controller |
| Language | English |
Describes the process of opening the door, including the role of the OPEN-contactor and limit switches.
Details the process of closing the door, including the CLOSE-contactor and limit switches.
Explains how to request a new calculation for automatic optimization of limit switch bands.
Describes how to adjust door end positions using parameters P.221 and P.231.
Configures input functions using parameters P.501 to P.A08 and related profiles.
Details functions for output relays K1-K6 (P.701-P.706) and their operational conditions.
Lists parameters for door cycle counter, hold times, and pre-warning times (P.000-025).
Details parameter P.205 for selecting the positioning system and teaching end positions.
Covers parameters P.215 and P.216 for requesting limit switch band calculations and correction.
Details parameter P.460 for specifying safety edge processing modes.
Displays variables like speed, current, voltage, temperature, and run-time via parameter P.910.
Explains how to access and interpret error memory and fault codes (P.920).
Shows how to display the software version of the controller (P.925).
Details how to display the motor run-time during the last door operation (P.930).
Describes how to reset the service counter using parameter P.973.
Explains how to select service modes like Automatic or Deadman using parameter P.980.
Details the process of entering the password for access using parameter P.999.
To Next Page
