To Next PageTo Next Page
Need help?Do you have a question about the Feig Electronic TST FUF2 Series and is the answer not in the manual?
General| Frequency | 13.56 MHz |
|---|---|
| Operating Temperature | -20 °C to +55 °C |
| Power Supply | 12-24 V DC |
| Operating Frequency | 13.56 MHz |
| Supported Transponders | ISO 15693 |
| Antenna Ports | 2 |
| Interface | RS232 |
| Communication Interface | Ethernet, RS232 |
Crucial safety instructions must be followed for personal safety and correct operation.
Contains copyright, version details, and legal disclaimers for the manual.
Explains document scope, language, product variants, and symbols used.
Details the electronic controller for industrial/commercial doors with frequency converter.
Identifies intended users and required qualifications for safe installation and maintenance.
Mandatory safety observations and warnings for operating and handling the controller.
Specifies requirements for safety-related signals and the complete safety chain.
Essential safety precautions and guidelines for correct controller installation.
Details on mounting the board set in a frame or other housing, including dimensions.
Dimensions and installation instructions for the controller in a plastic housing.
Dimensions for 300x400, 400x600, and 600x600mm steel/stainless steel variants.
Dimensions and installation details for hygiene housing variants (HZ, HY).
Procedure for mounting the TST FUxF-xPR board variant into a steel housing.
Crucial safety warnings and precautions for all electrical wiring and maintenance tasks.
Instructions for connecting power supply, motor, and brake components.
Wiring diagrams for safety edges, encoders, and mechanical limit switches.
Mapping of controller inputs and outputs for system integration and configuration.
Details on TST SFFE wireless receiver and TST SUVEK/VEK MNST loop detectors.
Information on RFUxK and RFUxIO expansion cards for added functionality.
Details on the RFUxFCOM interface card for RS-485 and CAN communication.
Guide to accessing and modifying controller parameters and operating modes.
Steps for initial setup, automatic data query, and controller commissioning.
Adjusting movement parameters for optimal door performance and calibration.
Comprehensive list of error codes, descriptions, and probable causes for troubleshooting.
Explanation of system status messages and indicators for operational feedback.
Detailed technical data including dimensions, voltage, current, and environmental ratings.
List of relevant safety, EMC, and low-voltage directives and standards.
