To Next PageTo Next Page
Need help?Do you have a question about the Feig Electronic TST FUZ2-CX and is the answer not in the manual?
General| Housing material | Plastic |
|---|---|
| Protection class | IP 65 |
| Operating Frequency | 13.56 MHz |
| Power Supply | 12-24 V DC |
| Operating Temperature | -20°C to +55°C |
| Communication Interface | RS-485, Ethernet |
Details the proper operation and context for the electronic controller.
Identifies and warns against improper or non-intended uses of the controller.
Highlights critical safety notes for startup, operation, installation, and wiring.
Details connecting the power cable using a CEE plug without a main switch.
Illustrates connecting the power cable when a main switch is installed.
Guides on connecting the motor cable, shielding, and brake rectifier.
Details connecting optical and electrical resistance safety edges to the controller.
Guides on installing and connecting the TST LGB light curtain as a safety device.
Explains connections for absolute encoders (PE, PD, DES) and mechanical limit switches.
Step-by-step guide to access and navigate the parameter setting mode.
Instructions for editing, saving, and exiting parameter settings.
Process for automatic retrieval and setting of essential controller parameters.
Setting motor parameters based on nameplate data for optimal performance.
Steps for commissioning the controller using encoder feedback for door positions.
Procedure for commissioning with mechanical limit switches, including pre-limits.
Steps to activate the TST LGB light curtain application and its automatic teach-in.
How to request a new teach-in for end positions if initial settings are unsuitable.
List of error codes, their descriptions, and possible reasons for occurrence.
