FEIG ELECTRONIC GmbH Page 89 of 96 TST_FUZ2-A-B-C-CX-G-L_Montageanleitung_EN_22.docx
13.2 Information messages
Emergency open test is running
Service counter will run off
Speed in open position to high
Speed in close position to high
Permanent open comand still active
Wait for foil key command
Wait for reset by stop foil key
New reference position taken over
Reference position new initialized
Limit switch not plausible (pre limit open)
Limit switch not plausible (pre limit close)
Disturbed N.C. safety edge
Disturbed N.O. safety edge
Faulty 2nd internal N.C. safety bar
Faulty 2nd internal N.O. safety bar
Correction drive finished
Target speed for opening or closing move not reached
• Pre-limit switch reached before full speed was reached --> adjust ramps
• Current limiter prevents movement at full speed --> Inverter or motor working at performance limit
--> adjust ramps or limiter
Measuring rotation factor not ready
Light line alignment completed successfully.
Light line alignment requested.
Door in PU when syncing but some rays of light are still masked.
Adjust P.446 door masking in PU!
The resolution of the installed position encoder is too low to maintain robust light curtain operation.
More increments are required per door move. (Message only occurs when DIP-Switch is ON.)
To Next Page
Loading...
Need help?
General
