Need help?Do you have a question about the Feig Electronic TST FU3E and is the answer not in the manual?
General| Brand | Feig Electronic |
|---|---|
| Model | TST FU3E |
| Category | Controller |
| Language | English |
Crucial information before operating the door controller.
Explains symbols used for hazards and useful tips.
Details on connecting the mains cable to the controller.
Diagram and notes for connecting the motor cable.
Wiring diagrams for various types of safety edges.
Guidance on connecting limit switches including absolute, mechanical, and incremental types.
Steps to enter the parameterizing mode.
How to change and save parameter values.
Procedure to leave the parameterizing mode.
How to reset the controller.
How the controller automatically queries basic data like positioning system.
Steps to modify preset parameters.
Startup procedure using encoders.
Startup procedure using mechanical limit switches.
How to re-teach end positions if initial ones are unsuitable.
Adjusting boost for increased motor power at low speeds.
Wiring diagram for connecting a photo eye.
Wiring diagram for external triggering devices.
Options for selecting display modes for diagnostics.
Options for selecting different service modes.
Internal errors that cannot be resolved by the user.
Error F.090: Basic parameters not set.
Faults related to the safety chain.
Various hardware faults detected by the controller.
Faults related to position sensing and synchronization.
General, calibration, synchronization, and deadman messages, including general inputs.
To Next Page
