143
TECHNICAL DATA
2. Tyre pressures
Text-module
Tyre pressure front
1.6 bar
Text-module
Tyre pressure rear
1.6 bar
Text-module
Caution:
Check tyre pressures regularly.
Always observe the tyre manufacturer's re-
commendations.
● Pressures may deviate depending on tractor
model, make of tyre and type of operation e.g.
front loader operation.
● For max. traction and min. ground pressure in
the field, adapt tyre pressures to axle loading.
● Operation on public roads with a tyre width of
2.5 m - 3.0 m (flotation tyres) requires a max.
tyre pressure of 1.5 bar.
● The load-bearing capacity is identified by an
"operating code" with a load-bearing capacity
code, e.g. 145 = 2,900 kg basic load-bearing
capacity per tyre, and a speed symbol, e.g.
A8 = 40 km/h reference speed.
● If a tyre that is suitable for speeds up to 40
km/h is used at 50 km/h, the load-bearing ca-
pacity of the tyre will be reduced by 9 %.
● Do not operate special-purpose wheels
above a maximum speed of 40 km/h.
● When operating the front loader, tyre pres-
sure should be increased.
To Next Page
Loading...
