41
OPERATION
Quick entry/hitch-lift (G)
Operation_Pic_number:1
Quick entry
● Set switch (E) to "Control"
● Push switch (G) forwards: implement sinks to
maximum depth (floating position).
● Release switch (G): implement returns to the
selected working depth.
Hitch-lift (for the trailer hook/hitch)
● Set quick lift lever (E) to "Lift".
● Raise powerlift until you reach electronic cu-
toff.
● Set switch (G) to "Hitch": the powerlift rises to
a maximum of a further 20 mm.
● Release switch: the powerlift remains in this
position.
External rear control panel
Operation_Pic_number:1
Buttons (A) to the left or right of the rear lamp: for
raising or lowering the lift.
If the safety lock comes into effect, external
operation of every setting of the quick lift switch
is possible.
Fig.68
Fig.69
16.3 Working with the EPC
Hitching three-point implements
Operation_Pic_number:1
● Turn dial (B) clockwise to "Position" setting
● Set quick lift lever (E) to "Control"
● Lower lift arms by turning the depth control
(F) anticlockwise. To raise the lift arms, turn
control clockwise.
Once the top and lower links are securely
attached to the implement,
● turn dial (D) anticlockwise.
● Set the depth control (F) to "0" or set the quick
lift lever (E) to "Lift". The implement is raised
to the lift height limit (approx. 1/4 of the total
lift height).
● Set the desired lift height by turning the lift
height limiter (D) clockwise.
Fig.70
To Next Page