72
CARE AND MAINTENANCE
10. Four-wheel drive
axle
10.1 Replacing the oil of the
front axle differential gear
Draining the oil
Operation_Pic_number:1
● Place oil pan underneath the housing.
● Unscrew and remove drain plug (A) and allow
the oil to drain completely.
● Clean the drain plug, refit and tighten.
Filling with oil
Operation_Pic_number:1
● Fill with specified oil through filler hole (A).
Fill until the oil spills over at the filler hole (A).
For frequency of changes, oil quantity and qua-
lity, refer to "Fuels and lubricants" or "Mainten-
ance schedule".
Fig.35
Fig.36
10.2 Replacing the oil for front
axle hub drives
Operation_Pic_number:1
Jack up the front axle until wheels rotate freely;
disengage the 4-WD.
Draining the oil
● Turn wheel until the hole is at the bottom.
● Place oil pan underneath.
● Remove drain plug and allow the oil to drain
completely.
● Clean the drain plug, refit and tighten.
Filling with oil
● Fill until the oil spills over (horizontal marker
and hole on the left).
For frequency of changes, oil quantity and qua-
lity, refer to "Fuels and lubricants" or "Mainten-
ance schedule".
Fig.37
To Next Page