Fermax 60305 - User Manual

Questions and Answers

E
Erica ShawAug 1, 2025
What to do if the door release on my Fermax Intercom System doesn't work well?
- L
  lindasmithAug 1, 2025
  If the door release is not functioning correctly, ensure that you are using a 12 Vdc door release with a maximum of 0.3 A. You may also need to increase the negative section, increase the section or add an additional power supply. Also, check the power supply position. The maximum distance from the panel should be 30 metres.
B
brittneyramosAug 5, 2025
Why does my Fermax 60305 Intercom System panel continually emit a series of short beeps?
- D
  David ZavalaAug 5, 2025
  The panel emits a series of short beeps because there is a short circuit between «L» and «-».
J
jenniferrojasAug 10, 2025
What does it mean when the Diagnostic LED emits short blinks when making a call on my Fermax Intercom System?
- K
  Kevin SimpsonAug 10, 2025
  The Diagnostic LED emitting short blinks during a call indicates a short circuit between «+» and «L», or that the cables are inverted.
J
Jennifer DoughertyAug 14, 2025
What does it mean when call button is pressed, the Diagnostic LED emits short blinks on Fermax Intercom System?
- W
  Wayne CordovaAug 14, 2025
  The short blinks of Diagnostic LED indicate a short circuit between «L» and «+».
A
adiazAug 19, 2025
What to do if there is no call, but panel monitoring on Fermax Intercom System?
- M
  Mercedes RoblesAug 19, 2025
  If there is no call but panel monitoring, check that the monitor is on and check cable «L». Also, the monitor might be programmed wrong, so programme it again.
R
Rachael OliverAug 22, 2025
What to do if when call button is pressed, the Diagnostic LED does not come on at all on Fermax 60305 Intercom System?
- A
  amy22Aug 23, 2025
  If the Diagnostic LED does not come on when the call button is pressed, check that the monitor is on and check cable «L». Also, the monitor might be programmed wrong, so programme it again.
J
Jesse SmithAug 27, 2025
Why is the audio sound very weak on my Fermax 60305 Intercom System, or has feedback that cannot be eliminated?
- R
  rebeccapetersAug 27, 2025
  If the audio sound is very weak, or there's feedback that cannot be eliminated, it is caused by Resistance 10 KOhms. There must be only 1 resistance in the furthest monitor.