To Next PageTo Next Page
Need help?Do you have a question about the Fermax FVI-6013MEM and is the answer not in the manual?
General| Brand | Fermax |
|---|---|
| Model | FVI-6013MEM |
| Category | Intercom System |
| Language | English |
Details the functions of the touchscreen, buttons, microphone, SD card slot, and connection port.
Explains terminal connections (L1, L2, SW+, SW-, Ring, GND, NC) and DIP switch settings for user code.
Details the lock control jumper and PIR motion detector connection port.
Explains the main connect port (L1, L2, PL, S+, S-) for bus line and electronic locks.
Explains how to program monitor addresses using DIP switch addressing for multi-monitor setups.
Procedure to program addresses for multiple door stations using KEY_SET and KEY_X buttons.
Details two methods for connecting electric locks: internal power and dry contact, including wiring and jumper settings.
Instructions on how to answer a call, communicate hands-free, and use controls like unlock and capture during communication.
How to release the door during a call, communication, or monitoring using screen icons or the UNLOCK button.
Steps to monitor specific door stations or cameras, including using the Monitor select page.
Explains automatic recording, which starts after 3 seconds of a call and captures one picture per call.
Guide on formatting micro-SD cards for the monitor, warning that all data will be erased.
How to view call records (incoming/outgoing/missed) from the Call Record icon on the main menu.
Instructions to enable motion detection for the door station and its integration with external detectors.
Guide on restoring monitor settings to factory defaults using the About menu.
Procedure to enter the installer setup menu by holding the UNLOCK button on the front panel.
Instructions on setting monitors as master or slave for multi-monitor systems, ensuring correct address assignment.
Using DIP switches to set the user code and apartment address, including Bit-1 to Bit-5 and Bit-6.
Detailed steps to set addresses (0-3) for up to four door stations using KEY_SET and specific KEY buttons.
Details on connecting electric locks using internal power, including type, voltage, current limits, and jumper settings.
Instructions for connecting electric locks using dry contact, specifying external power supply and relay limitations.
