2. Safety instructions for electrical drives and controllers
12 Festo P.BE-CMMS-AS-HW-EN en 0708NH
2.2 General Information
Festo AG & Co.KG is not liable for damage caused by failure to observe the warning in-
structions in these operating instructions.
Please note
Before initial start-up, read through the 211HSafety instructions for elec-
trical drives and controllers starting on page 212H11 and the chapter 213H6.5
214HInstructions on safe and EMC-compliant
installation page 215H101.
If the documentation in the language in question cannot be understood fully, please con-
tact your vendor and inform them.
Proper and safe operation of the motor controller requires correct transport, storage,
mounting and installation as well as project planning, taking into account the risks, protec-
tion and emergency measures, as well as careful operation and maintenance.
Please note
Only trained and qualified personnel should be allowed to handle
the electric systems.
Trained and qualified personnel
For the purpose of this manual and the warning instructions on the product itself, techni-
cians working with this product must be adequately familiar with the setting up, mounting,
commissioning and operation of the product as well as with all warnings and precautionary
measures in accordance with the operating instructions in this product manual, and must
be sufficiently qualified for this task:
- Training and instructions on or authorization to switch on and switch off de-
vices/systems in accordance with technical safety standards, and to earth and
mark them appropriately in accordance with the application requirements.
- Training or instructions in using and maintaining suitable safety equipment in
accordance with technical safety standards.
- Training in first aid.
The following instructions must be read before the first start-up of the sytem in order that
bodily injuries and/or damage to property can be avoided.
These safety instructions must be observed at all times.
To Next Page
Loading...
Need help?
General
