2. Safety instructions for electrical drives and controllers
Festo P.BE-CMMS-AS-HW-EN en 0708NH 15
Precautionary measures must be taken for preventing interference
to switching systems, e.g. switching protective switches and relays
with RC elements or diodes.
You must observe the safety regulations and directives of the coun-
try in which the device is to be used.
Warning
The environmental conditions specified in the product docu-
mentation must be observed.
Safety-critical applications are not permitted if they are not explic-
itly approved by the manufacturer.
For instructions on safe and EMC-compliant installation, see
Chapter 216H6.5 217HInstructions on safe and EMC-compliant
installation (page 218H101).The instructions for EMC-compliant in-
stallation.
The manufacturer of the system or machine is responsible for en-
suring that the limit values required by the national regulations are
observed.
Warning
The technical specifications as well as the connection and installa-
tion conditions for the motor controller can be found in this product
manual. These specifications must be observed at all times.
Warning
DANGER !
The general installation and safety regulations for working on
high-current systems (e.g. DIN, VDE, EN, IEC or other national
and international regulations) must be observed.
Failure to observe these regulations can lead to bodily injury, death
or considerable damage to property.
The following precautionary measures also apply without claim to
completeness:
Regulations for setting up high-voltage systems up
to 1,000 volts
Electrical equipment for machines.
Equipping high-voltage systems with electronic
To Next Page
Loading...
Need help?
General
