© 2008 Festo Corporation 6 U
Safety *
Due to the potential hazards in any automated system, good safety practices are important in
the classroom, as well as on the production floor.
Students should never be allowed to place their hands on or near the system while operating.
Safety glasses should be worn around the equipment during operation.
*See also page 7, “Operation of the Festo Training System,” for
additional safety considerations.
All information in this workbook is intended for educational use only. It has
been carefully compiled and checked, and we beli
eve the material to be accu-
rately presented. However, Festo Corporation assumes no responsibility for
published technical errors. Additionally, Festo Corporation assumes no re-
sponsibility for the safe and/or satisfactory operation of any machine.
All information in this workbook is intended for educational use only. It has
been carefully compiled and checked, and we believe the material to be accu-
rately presented. However, Festo Corporation assumes no responsibility for
published technical errors. Additionally, Festo Corporation assumes no re-
sponsibility for the safe and/or satisfactory operation of any machine.
To Next Page
Loading...
