FIBER FOX Mini 6S+ - Error Messages and Solutions

41
Error Message Cause Solution
Left Fiber Place
Error
The ber end-face is placed
on the electrode centerline.
Press RESET button, and reload the bers
to make sure that ber end face is placed
between V-groove and the centerline of
electrodes.
Right Fiber Place
Error
Press Motor Distance
Over Limit
The ber is not set correctly
at the bottom of the
V-groove, which results in
that the ber osets beyond
motor formation range.
Press the “RESET” button; correctly re-
position the ber at the bottom of the
V-groove.
Press Motor Error Motor might be damaged. Consult your nearest sales agent.
Search Fiber End
face Failed
The ber is not set
correctly at the bottom of
the V-groove.
Press the “RESET” button; correctly re-
position the ber at the bottom of the
V-groove.
Arc Failure
Arc discharge does not
occur.
Conrm the electrodes are in proper
position; Replace the electrodes.
Align Motor Distance
Over Limit
The ber is not set correctly
at the bottom of the
V-groove.
Press the “RESET” button; correctly re-
position the ber at the bottom of the
V-groove.
Search Fiber Clad
Failed
The ber is not set
correctly at the bottom of
the V-groove.
Press the “RESET” button; correctly re-
position the ber at the bottom of the
V-groove.
Fiber Border
Position Wrong
There’s dust or dirt on the
ber surface
Prepare the ber (stripping, cleaning, and
cleaving) again; clean the lens; redo [Dust
Check]
Unknown Fiber Type
There’s dust or dirt on the
ber surface
Prepare the ber (stripping,
cleaning, and cleaving) again.
Dierent ber types on two
sides.
Use an appropriate splice mode other than
AUTO splice mode to re -splice.
Non-standard optical bers
AUTO splice mode can only detect the
standard SM, MM, NZ bers.
Fiber Clad Over
Limit
Fiber edge is not located in
the camera range.
Adjust the ber position and perform “motor
calibration” .
Appendix B
During the splice operating process, if the error messages are shown on the screen,
please follow the solution precisely as shown in the list below. If it is not possible to
solve the problem, the splicer may require service by a qualied service center. In
this case, please contact sales agents.
High Splice loss: Cause and solutions